samydavisjr
- samydavisjr
-
New Member
-
Posts:
-
Joined:Sun Mar 27, 2011 7:35 pm
? I am working on rotating the steering nuckles on a dana 60. I have some high content nickel rod from lincoln that has worked well for me on cast. I have a good bit of build up to do in some areas and would prefure to run wire feed. Is anyone familiar with this process, and if so could you recomend a good wire? Also while were on it does anyone know what kind of cast is used for nuckles and differentials, what temps for pre and post heating so on?
samydavisjr
- samydavisjr
-
New Member
-
Posts:
-
Joined:Sun Mar 27, 2011 7:35 pm
Forgot to ask: Lincoln had broblems with NR211 being brittle and came out with NR212, which is a more ductile filler. Anyone had experience with using this on cast?
TheExpert
- TheExpert
-
Workhorse
-
Posts:
-
Joined:Thu Sep 08, 2011 7:48 am
-
Contact:
Sorry I have never try this, but if I get some information I will provide you at here.